Content-Disposition: inline; filename=hwmon-documentation-typos.patch hwmon: Fix documentation typos Fix typos in hardware monitoring documentation. Signed-off-by: Jean Delvare --- Documentation/hwmon/f71805f | 2 +- Documentation/hwmon/w83627ehf | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-) --- linux-2.6.19-rc1.orig/Documentation/hwmon/w83627ehf 2006-10-08 12:48:09.000000000 +0200 +++ linux-2.6.19-rc1/Documentation/hwmon/w83627ehf 2006-10-08 15:04:02.000000000 +0200 @@ -26,7 +26,7 @@ Temperatures are measured in degrees Celsius and measurement resolution is 1 degC for temp1 and 0.5 degC for temp2 and temp3. An alarm is triggered when the temperature gets higher than high limit; it stays on until the temperature -falls below the Hysteresis value. +falls below the hysteresis value. Fan rotation speeds are reported in RPM (rotations per minute). An alarm is triggered if the rotation speed has dropped below a programmable limit. Fan @@ -67,9 +67,9 @@ If the temperature is in the range defined by: -pwm[1-4]_target - set target temperature, unit millidegree Celcius +pwm[1-4]_target - set target temperature, unit millidegree Celsius (range 0 - 127000) -pwm[1-4]_tolerance - tolerance, unit millidegree Celcius (range 0 - 15000) +pwm[1-4]_tolerance - tolerance, unit millidegree Celsius (range 0 - 15000) there are no changes to fan speed. Once the temperature leaves the interval, fan speed increases (temp is higher) or decreases if lower than desired. --- linux-2.6.19-rc1.orig/Documentation/hwmon/f71805f 2006-10-08 12:48:09.000000000 +0200 +++ linux-2.6.19-rc1/Documentation/hwmon/f71805f 2006-10-08 14:59:21.000000000 +0200 @@ -17,7 +17,7 @@ providing additional documentation. Thanks to Chris Lin from Jetway for providing wiring schematics and -anwsering technical questions. +answering technical questions. Description