From: Jiri Slaby Too many information is printed out (they may be easily obtained through sysfs), wipe them out in probe function. Convert rest of them to dev_ variants. Signed-off-by: Jiri Slaby Cc: Alan Cox Signed-off-by: Andrew Morton --- drivers/char/stallion.c | 15 ++------------- 1 file changed, 2 insertions(+), 13 deletions(-) diff -puN drivers/char/stallion.c~char-stallion-prints-cleanup drivers/char/stallion.c --- a/drivers/char/stallion.c~char-stallion-prints-cleanup +++ a/drivers/char/stallion.c @@ -2423,9 +2423,6 @@ static int __devinit stl_pciprobe(struct struct stlbrd *brdp; unsigned int brdtype = ent->driver_data; - pr_debug("stl_initpcibrd(brdtype=%d,busnr=%x,devnr=%x)\n", brdtype, - pdev->bus->number, pdev->devfn); - if ((pdev->class >> 8) == PCI_CLASS_STORAGE_IDE) return -ENODEV; @@ -2437,21 +2434,13 @@ static int __devinit stl_pciprobe(struct if ((brdp = stl_allocbrd()) == NULL) return(-ENOMEM); if ((brdp->brdnr = stl_getbrdnr()) < 0) { - printk("STALLION: too many boards found, " + dev_err(&pdev->dev, "too many boards found, " "maximum supported %d\n", STL_MAXBRDS); return(0); } brdp->brdtype = brdtype; /* - * Different Stallion boards use the BAR registers in different ways, - * so set up io addresses based on board type. - */ - pr_debug("%s(%d): BAR[]=%Lx,%Lx,%Lx,%Lx IRQ=%x\n", __FILE__, __LINE__, - pci_resource_start(pdev, 0), pci_resource_start(pdev, 1), - pci_resource_start(pdev, 2), pci_resource_start(pdev, 3), pdev->irq); - -/* * We have all resources from the board, so let's setup the actual * board structure now. */ @@ -2469,7 +2458,7 @@ static int __devinit stl_pciprobe(struct brdp->ioaddr2 = pci_resource_start(pdev, 1); break; default: - printk("STALLION: unknown PCI board type=%d\n", brdtype); + dev_err(&pdev->dev, "unknown PCI board type=%u\n", brdtype); break; } _