From: Linas Vepstas Add PCI error recovery support to the s2io 10-Gigabit ethernet device driver. Fourth revision, blocks interrupts and the watchdog. Adds a flag to s2io_down(), to avoid doing I/O when PCI bus is offline. Signed-off-by: Linas Vepstas Acked-by: Ramkrishna Vepa Cc: Raghavendra Koushik Cc: Ananda Raju Cc: Wen Xiong Signed-off-by: Andrew Morton --- drivers/net/s2io.c | 116 +++++++++++++++++++++++++++++++++++++++++-- drivers/net/s2io.h | 5 + 2 files changed, 116 insertions(+), 5 deletions(-) diff -puN drivers/net/s2io.c~s2io-add-pci-error-recovery-support drivers/net/s2io.c --- a/drivers/net/s2io.c~s2io-add-pci-error-recovery-support +++ a/drivers/net/s2io.c @@ -459,11 +459,18 @@ static struct pci_device_id s2io_tbl[] _ MODULE_DEVICE_TABLE(pci, s2io_tbl); +static struct pci_error_handlers s2io_err_handler = { + .error_detected = s2io_io_error_detected, + .slot_reset = s2io_io_slot_reset, + .resume = s2io_io_resume, +}; + static struct pci_driver s2io_driver = { .name = "S2IO", .id_table = s2io_tbl, .probe = s2io_init_nic, .remove = __devexit_p(s2io_rem_nic), + .err_handler = &s2io_err_handler, }; /* A simplifier macro used both by init and free shared_mem Fns(). */ @@ -2618,6 +2625,9 @@ static void s2io_netpoll(struct net_devi u64 val64 = 0xFFFFFFFFFFFFFFFFULL; int i; + if (pci_channel_offline(nic->pdev)) + return; + disable_irq(dev->irq); atomic_inc(&nic->isr_cnt); @@ -3120,6 +3130,8 @@ static void alarm_intr_handler(struct s2 int i; if (atomic_read(&nic->card_state) == CARD_DOWN) return; + if (pci_channel_offline(nic->pdev)) + return; nic->mac_control.stats_info->sw_stat.ring_full_cnt = 0; /* Handling the XPAK counters update */ if(nic->mac_control.stats_info->xpak_stat.xpak_timer_count < 72000) { @@ -4176,6 +4188,10 @@ static irqreturn_t s2io_isr(int irq, voi struct mac_info *mac_control; struct config_param *config; + /* Pretend we handled any irq's from a disconnected card */ + if (pci_channel_offline(sp->pdev)) + return IRQ_NONE; + atomic_inc(&sp->isr_cnt); mac_control = &sp->mac_control; config = &sp->config; @@ -6351,7 +6367,7 @@ static void s2io_rem_isr(struct s2io_nic } while(cnt < 5); } -static void s2io_card_down(struct s2io_nic * sp) +static void do_s2io_card_down(struct s2io_nic * sp, int do_io) { int cnt = 0; struct XENA_dev_config __iomem *bar0 = sp->bar0; @@ -6366,7 +6382,8 @@ static void s2io_card_down(struct s2io_n atomic_set(&sp->card_state, CARD_DOWN); /* disable Tx and Rx traffic on the NIC */ - stop_nic(sp); + if (do_io) + stop_nic(sp); s2io_rem_isr(sp); @@ -6374,7 +6391,7 @@ static void s2io_card_down(struct s2io_n tasklet_kill(&sp->task); /* Check if the device is Quiescent and then Reset the NIC */ - do { + while(do_io) { /* As per the HW requirement we need to replenish the * receive buffer to avoid the ring bump. Since there is * no intention of processing the Rx frame at this pointwe are @@ -6399,8 +6416,9 @@ static void s2io_card_down(struct s2io_n (unsigned long long) val64); break; } - } while (1); - s2io_reset(sp); + } + if (do_io) + s2io_reset(sp); spin_lock_irqsave(&sp->tx_lock, flags); /* Free all Tx buffers */ @@ -6415,6 +6433,11 @@ static void s2io_card_down(struct s2io_n clear_bit(0, &(sp->link_state)); } +static void s2io_card_down(struct s2io_nic * sp) +{ + do_s2io_card_down(sp, 1); +} + static int s2io_card_up(struct s2io_nic * sp) { int i, ret = 0; @@ -7736,3 +7759,86 @@ static void lro_append_pkt(struct s2io_n sp->mac_control.stats_info->sw_stat.clubbed_frms_cnt++; return; } + +/** + * s2io_io_error_detected - called when PCI error is detected + * @pdev: Pointer to PCI device + * @state: The current pci conneection state + * + * This function is called after a PCI bus error affecting + * this device has been detected. + */ +static pci_ers_result_t s2io_io_error_detected(struct pci_dev *pdev, + pci_channel_state_t state) +{ + struct net_device *netdev = pci_get_drvdata(pdev); + struct s2io_nic *sp = netdev->priv; + + netif_device_detach(netdev); + + if (netif_running(netdev)) { + /* Bring down the card, while avoiding PCI I/O */ + do_s2io_card_down(sp, 0); + sp->device_close_flag = TRUE; /* Device is shut down. */ + } + pci_disable_device(pdev); + + return PCI_ERS_RESULT_NEED_RESET; +} + +/** + * s2io_io_slot_reset - called after the pci bus has been reset. + * @pdev: Pointer to PCI device + * + * Restart the card from scratch, as if from a cold-boot. + * At this point, the card has exprienced a hard reset, + * followed by fixups by BIOS, and has its config space + * set up identically to what it was at cold boot. + */ +static pci_ers_result_t s2io_io_slot_reset(struct pci_dev *pdev) +{ + struct net_device *netdev = pci_get_drvdata(pdev); + struct s2io_nic *sp = netdev->priv; + + if (pci_enable_device(pdev)) { + printk(KERN_ERR "s2io: " + "Cannot re-enable PCI device after reset.\n"); + return PCI_ERS_RESULT_DISCONNECT; + } + + pci_set_master(pdev); + s2io_reset(sp); + + return PCI_ERS_RESULT_RECOVERED; +} + +/** + * s2io_io_resume - called when traffic can start flowing again. + * @pdev: Pointer to PCI device + * + * This callback is called when the error recovery driver tells + * us that its OK to resume normal operation. + */ +static void s2io_io_resume(struct pci_dev *pdev) +{ + struct net_device *netdev = pci_get_drvdata(pdev); + struct s2io_nic *sp = netdev->priv; + + if (netif_running(netdev)) { + if (s2io_card_up(sp)) { + printk(KERN_ERR "s2io: " + "Can't bring device back up after reset.\n"); + return; + } + + if (s2io_set_mac_addr(netdev, netdev->dev_addr) == FAILURE) { + s2io_card_down(sp); + printk(KERN_ERR "s2io: " + "Can't resetore mac addr after reset.\n"); + return; + } + } + + netif_device_attach(netdev); + netif_wake_queue(netdev); +} diff -puN drivers/net/s2io.h~s2io-add-pci-error-recovery-support drivers/net/s2io.h --- a/drivers/net/s2io.h~s2io-add-pci-error-recovery-support +++ a/drivers/net/s2io.h @@ -1026,6 +1026,11 @@ static void lro_append_pkt(struct s2io_n struct sk_buff *skb, u32 tcp_len); static int rts_ds_steer(struct s2io_nic *nic, u8 ds_codepoint, u8 ring); +static pci_ers_result_t s2io_io_error_detected(struct pci_dev *pdev, + pci_channel_state_t state); +static pci_ers_result_t s2io_io_slot_reset(struct pci_dev *pdev); +static void s2io_io_resume(struct pci_dev *pdev); + #define s2io_tcp_mss(skb) skb_shinfo(skb)->gso_size #define s2io_udp_mss(skb) skb_shinfo(skb)->gso_size #define s2io_offload_type(skb) skb_shinfo(skb)->gso_type _