i386: revert i386-fix-the-verify_quirk_intel_irqbalance From: Andrew Morton This is unneeded with Ingo's genapic rework. Cc: Suresh Siddha Cc: Andi Kleen Cc: Ingo Molnar Signed-off-by: Andrew Morton Signed-off-by: Andi Kleen --- arch/i386/kernel/quirks.c | 33 ++++----------------------------- 1 file changed, 4 insertions(+), 29 deletions(-) Index: linux/arch/i386/kernel/quirks.c =================================================================== --- linux.orig/arch/i386/kernel/quirks.c +++ linux/arch/i386/kernel/quirks.c @@ -10,38 +10,13 @@ #if defined(CONFIG_X86_IO_APIC) && defined(CONFIG_SMP) && defined(CONFIG_PCI) static void __devinit verify_quirk_intel_irqbalance(struct pci_dev *dev) { - u8 config, rev; - u32 word; - - /* BIOS may enable hardware IRQ balancing for - * E7520/E7320/E7525(revision ID 0x9 and below) - * based platforms. - * For those platforms, make sure that the genapic is set to 'flat' - */ - pci_read_config_byte(dev, PCI_CLASS_REVISION, &rev); - if (rev > 0x9) - return; - - /* enable access to config space*/ - pci_read_config_byte(dev, 0xf4, &config); - pci_write_config_byte(dev, 0xf4, config|0x2); - - /* read xTPR register */ - raw_pci_ops->read(0, 0, 0x40, 0x4c, 2, &word); - - if (!(word & (1 << 13))) { #ifdef CONFIG_X86_64 - if (genapic != &apic_flat) - panic("APIC mode must be flat on this system\n"); + if (genapic != &apic_flat) + panic("APIC mode must be flat on this system\n"); #elif defined(CONFIG_X86_GENERICARCH) - if (genapic != &apic_default) - panic("APIC mode must be default(flat) on this system. Use apic=default\n"); + if (genapic != &apic_default) + panic("APIC mode must be default(flat) on this system. Use apic=default\n"); #endif - } - - /* put back the original value for config space*/ - if (!(config & 0x2)) - pci_write_config_byte(dev, 0xf4, config); } void __init quirk_intel_irqbalance(void)