From: Sascha Hauer Here are some small fixes for the imxfb framebuffer driver: - remove ifndef for MX1FS2 platform which is not present in the kernel. - REV, CLS, PS and SPL_SPR are only needed with some sharp displays. Only setup the corresponding io pins when such a display is connected. Signed-off-by: Sascha Hauer Signed-off-by: Antonino Daplas Signed-off-by: Andrew Morton --- drivers/video/imxfb.c | 23 ++++++++--------------- 1 files changed, 8 insertions(+), 15 deletions(-) diff -puN drivers/video/imxfb.c~imxfb-remove-ifdefs drivers/video/imxfb.c --- a/drivers/video/imxfb.c~imxfb-remove-ifdefs +++ a/drivers/video/imxfb.c @@ -394,26 +394,18 @@ static void imxfb_setup_gpio(struct imxf /* initialize GPIOs */ imx_gpio_mode(PD6_PF_LSCLK); - imx_gpio_mode(PD10_PF_SPL_SPR); imx_gpio_mode(PD11_PF_CONTRAST); imx_gpio_mode(PD14_PF_FLM_VSYNC); imx_gpio_mode(PD13_PF_LP_HSYNC); - imx_gpio_mode(PD7_PF_REV); - imx_gpio_mode(PD8_PF_CLS); - -#ifndef CONFIG_MACH_PIMX1 - /* on PiMX1 used as buffers enable signal - */ - imx_gpio_mode(PD9_PF_PS); -#endif - -#ifndef CONFIG_MACH_MX1FS2 - /* on mx1fs2 this pin is used to (de)activate the display, so we need - * it as a normal gpio - */ imx_gpio_mode(PD12_PF_ACD_OE); -#endif + /* These are only needed for Sharp HR TFT displays */ + if (fbi->pcr & PCR_SHARP) { + imx_gpio_mode(PD7_PF_REV); + imx_gpio_mode(PD8_PF_CLS); + imx_gpio_mode(PD9_PF_PS); + imx_gpio_mode(PD10_PF_SPL_SPR); + } } #ifdef CONFIG_PM @@ -499,6 +491,7 @@ static int __init imxfb_init_fbinfo(stru info->var.sync = inf->sync; info->var.grayscale = inf->cmap_greyscale; fbi->cmap_inverse = inf->cmap_inverse; + fbi->cmap_static = inf->cmap_static; fbi->pcr = inf->pcr; fbi->lscr1 = inf->lscr1; fbi->dmacr = inf->dmacr; _