From stern@rowland.harvard.edu Fri May 4 08:55:35 2007 From: Alan Stern Date: Fri, 4 May 2007 11:55:31 -0400 (EDT) Subject: USB: EHCI: fix handover for designated full-speed ports To: Greg KH Message-ID: This patch (as895) fixes up a loose end in the port-handover code for the USB-Persist facility. A special case occurs when a high-speed device is attached to a port which the user has designated to run at full-speed only; the port must be disabled before the handover can take place. Signed-off-by: Alan Stern Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/ehci-hub.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) --- a/drivers/usb/host/ehci-hub.c +++ b/drivers/usb/host/ehci-hub.c @@ -60,11 +60,13 @@ static void ehci_handover_companion_port while (port--) { if (test_bit(port, &ehci->owned_ports)) { reg = &ehci->regs->port_status[port]; - status = ehci_readl(ehci, reg); + status = ehci_readl(ehci, reg) & ~PORT_RWC_BITS; /* Port already owned by companion? */ if (status & PORT_OWNER) clear_bit(port, &ehci->owned_ports); + else if (test_bit(port, &ehci->companion_ports)) + ehci_writel(ehci, status & ~PORT_PE, reg); else ehci_hub_control(hcd, SetPortFeature, USB_PORT_FEAT_RESET, port + 1,