[PATCH] ide-pmac: remove extra good status wait from pmac_ide_do_setfeature() Don't check for good device status before executing the command in pmac_ide_do_setfeature() (ide_config_drive_speed() doesn't do this). It is a job of upper layers to guarantee that the device is ready to accept new command before we get here. Cc: Benjamin Herrenschmidt Signed-off-by: Bartlomiej Zolnierkiewicz --- drivers/ide/ppc/pmac.c | 12 +----------- 1 file changed, 1 insertion(+), 11 deletions(-) Index: b/drivers/ide/ppc/pmac.c =================================================================== --- a/drivers/ide/ppc/pmac.c +++ b/drivers/ide/ppc/pmac.c @@ -547,16 +547,6 @@ pmac_ide_do_setfeature(ide_drive_t *driv SELECT_DRIVE(drive); SELECT_MASK(drive, 0); udelay(1); - /* Get rid of pending error state */ - (void) hwif->INB(IDE_STATUS_REG); - /* Timeout bumped for some powerbooks */ - if (wait_for_ready(drive, 2000)) { - /* Timeout bumped for some powerbooks */ - printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready " - "before SET_FEATURE!\n", drive->name); - goto out; - } - udelay(10); hwif->OUTB(drive->ctl | 2, IDE_CONTROL_REG); hwif->OUTB(command, IDE_NSECTOR_REG); hwif->OUTB(SETFEATURES_XFER, IDE_FEATURE_REG); @@ -568,7 +558,7 @@ pmac_ide_do_setfeature(ide_drive_t *driv if (result) printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready " "after SET_FEATURE !\n", drive->name); -out: + SELECT_MASK(drive, 0); if (result == 0) { drive->id->dma_ultra &= ~0xFF00;