From: Bartlomiej Zolnierkiewicz Subject: [PATCH] cmd640: remove cmd_drives[] * Pass 'ide_drive_t *drive' to check_prefetch(), set_prefetch_mode(), program_drive_counts() and cmd640_set_mode(). * Remove no longer needed cmd_drives[]. * Inline setup_device_ptrs() helper in cmd640x_init(). Signed-off-by: Bartlomiej Zolnierkiewicz --- drivers/ide/pci/cmd640.c | 67 ++++++++++++++++++----------------------------- 1 file changed, 27 insertions(+), 40 deletions(-) Index: b/drivers/ide/pci/cmd640.c =================================================================== --- a/drivers/ide/pci/cmd640.c +++ b/drivers/ide/pci/cmd640.c @@ -185,7 +185,6 @@ static DEFINE_SPINLOCK(cmd640_lock); * These are initialized to point at the devices we control */ static ide_hwif_t *cmd_hwif0, *cmd_hwif1; -static ide_drive_t *cmd_drives[4]; /* * Interface to access cmd640x registers @@ -386,9 +385,8 @@ static void cmd640_dump_regs (void) * Check whether prefetch is on for a drive, * and initialize the unmask flags for safe operation. */ -static void __init check_prefetch (unsigned int index) +static void __init check_prefetch(ide_drive_t *drive, unsigned int index) { - ide_drive_t *drive = cmd_drives[index]; u8 b = get_cmd640_reg(prefetch_regs[index]); if (b & prefetch_masks[index]) { /* is prefetch off? */ @@ -404,28 +402,13 @@ static void __init check_prefetch (unsig } } -/* - * Figure out which devices we control - */ -static void __init setup_device_ptrs (void) -{ - cmd_hwif0 = &ide_hwifs[0]; - cmd_hwif1 = &ide_hwifs[1]; - - cmd_drives[0] = &cmd_hwif0->drives[0]; - cmd_drives[1] = &cmd_hwif0->drives[1]; - cmd_drives[2] = &cmd_hwif1->drives[0]; - cmd_drives[3] = &cmd_hwif1->drives[1]; -} - #ifdef CONFIG_BLK_DEV_CMD640_ENHANCED /* * Sets prefetch mode for a drive. */ -static void set_prefetch_mode (unsigned int index, int mode) +static void set_prefetch_mode(ide_drive_t *drive, unsigned int index, int mode) { - ide_drive_t *drive = cmd_drives[index]; unsigned long flags; int reg = prefetch_regs[index]; u8 b; @@ -508,7 +491,7 @@ static void __init retrieve_drive_counts * This routine writes the prepared setup/active/recovery counts * for a drive into the cmd640 chipset registers to active them. */ -static void program_drive_counts (unsigned int index) +static void program_drive_counts(ide_drive_t *drive, unsigned int index) { unsigned long flags; u8 setup_count = setup_counts[index]; @@ -522,8 +505,11 @@ static void program_drive_counts (unsign * so we merge the timings, using the slowest value for each timing. */ if (index > 1) { - unsigned int mate; - if (cmd_drives[mate = index ^ 1]->present) { + ide_hwif_t *hwif = drive->hwif; + ide_drive_t *peer = &hwif->drives[!drive->select.b.unit]; + unsigned int mate = index ^ 1; + + if (peer->present) { if (setup_count < setup_counts[mate]) setup_count = setup_counts[mate]; if (active_count < active_counts[mate]) @@ -562,7 +548,8 @@ static void program_drive_counts (unsign /* * Set a specific pio_mode for a drive */ -static void cmd640_set_mode (unsigned int index, u8 pio_mode, unsigned int cycle_time) +static void cmd640_set_mode(ide_drive_t *drive, unsigned int index, + u8 pio_mode, unsigned int cycle_time) { int setup_time, active_time, recovery_time, clock_time; u8 setup_count, active_count, recovery_count, recovery_count2, cycle_count; @@ -611,7 +598,7 @@ static void cmd640_set_mode (unsigned in * 1) this is the wrong place to do it (proper is do_special() in ide.c) * 2) in practice this is rarely, if ever, necessary */ - program_drive_counts (index); + program_drive_counts(drive, index); } static void cmd640_set_pio_mode(ide_drive_t *drive, const u8 pio) @@ -619,13 +606,6 @@ static void cmd640_set_pio_mode(ide_driv unsigned int index = 0, cycle_time; u8 b; - while (drive != cmd_drives[index]) { - if (++index > 3) { - printk(KERN_ERR "%s: bad news in %s\n", - drive->name, __FUNCTION__); - return; - } - } switch (pio) { case 6: /* set fast-devsel off */ case 7: /* set fast-devsel on */ @@ -638,13 +618,13 @@ static void cmd640_set_pio_mode(ide_driv case 8: /* set prefetch off */ case 9: /* set prefetch on */ - set_prefetch_mode(index, pio & 1); + set_prefetch_mode(drive, index, pio & 1); printk("%s: %sabled cmd640 prefetch\n", drive->name, (pio & 1) ? "en" : "dis"); return; } cycle_time = ide_pio_cycle_time(drive, pio); - cmd640_set_mode(index, pio, cycle_time); + cmd640_set_mode(drive, index, pio, cycle_time); printk("%s: selected cmd640 PIO mode%d (%dns)", drive->name, pio, cycle_time); @@ -764,11 +744,12 @@ static int __init cmd640x_init(void) printk(KERN_INFO "cmd640: buggy cmd640%c interface on %s, config=0x%02x" "\n", 'a' + cmd640_chip_version - 1, bus_type, cfr); + cmd_hwif0 = &ide_hwifs[0]; + cmd_hwif1 = &ide_hwifs[1]; + /* * Initialize data for primary port */ - setup_device_ptrs (); - ide_init_port_hw(cmd_hwif0, &hw[0]); #ifdef CONFIG_BLK_DEV_CMD640_ENHANCED cmd_hwif0->set_pio_mode = &cmd640_set_pio_mode; @@ -837,7 +818,13 @@ static int __init cmd640x_init(void) * Do not unnecessarily disturb any prior BIOS setup of these. */ for (index = 0; index < (2 + (second_port_cmd640 << 1)); index++) { - ide_drive_t *drive = cmd_drives[index]; + ide_drive_t *drive; + + if (index > 1) + drive = &cmd_hwif1->drives[index & 1]; + else + drive = &cmd_hwif0->drives[index & 1]; + #ifdef CONFIG_BLK_DEV_CMD640_ENHANCED if (drive->autotune || ((index > 1) && second_port_toggled)) { /* @@ -847,8 +834,8 @@ static int __init cmd640x_init(void) setup_counts [index] = 4; /* max possible */ active_counts [index] = 16; /* max possible */ recovery_counts [index] = 16; /* max possible */ - program_drive_counts (index); - set_prefetch_mode (index, 0); + program_drive_counts(drive, index); + set_prefetch_mode(drive, index, 0); printk("cmd640: drive%d timings/prefetch cleared\n", index); } else { /* @@ -856,7 +843,7 @@ static int __init cmd640x_init(void) * This preserves any prior BIOS setup. */ retrieve_drive_counts (index); - check_prefetch (index); + check_prefetch(drive, index); printk("cmd640: drive%d timings/prefetch(%s) preserved", index, drive->no_io_32bit ? "off" : "on"); display_clocks(index); @@ -865,7 +852,7 @@ static int __init cmd640x_init(void) /* * Set the drive unmask flags to match the prefetch setting */ - check_prefetch (index); + check_prefetch(drive, index); printk("cmd640: drive%d timings/prefetch(%s) preserved\n", index, drive->no_io_32bit ? "off" : "on"); #endif /* CONFIG_BLK_DEV_CMD640_ENHANCED */