From JBeulich@novell.com Mon Aug 17 12:30:34 2009 From: "Jan Beulich" Date: Mon, 17 Aug 2009 05:54:31 -0600 Subject: Staging: hv: adjust Hyper-V Kconfig To: "Greg Kroah-Hartman" Content-Disposition: inline From: Jan Beulich Hyper-V sub-components' options should all depend on the base option. The default of these sub-component options is also more reasonably set to that of the base option (since it makes little sense to enable the base option without the sub-component ones). Signed-off-by: Jan Beulich Cc: Hank Janssen Signed-off-by: Greg Kroah-Hartman --- drivers/staging/hv/Kconfig | 16 ++++++++++------ 1 file changed, 10 insertions(+), 6 deletions(-) --- a/drivers/staging/hv/Kconfig +++ b/drivers/staging/hv/Kconfig @@ -6,23 +6,27 @@ config HYPERV Select this option to run Linux as a Hyper-V client operating system. +if HYPERV + config HYPERV_STORAGE tristate "Microsoft Hyper-V virtual storage driver" - depends on SCSI && m - default n + depends on SCSI + default HYPERV help Select this option to enable the Hyper-V virtual storage driver. config HYPERV_BLOCK tristate "Microsoft Hyper-V virtual block driver" - depends on BLOCK && SCSI && m - default n + depends on BLOCK && SCSI + default HYPERV help Select this option to enable the Hyper-V virtual block driver. config HYPERV_NET tristate "Microsoft Hyper-V virtual network driver" - depends on NET && m - default n + depends on NET + default HYPERV help Select this option to enable the Hyper-V virtual network driver. + +endif